A518/A500 overdrive into 62 B body ?

[rustytoolss]

I have an A500 overdrive transmission. At some point I would like to install it into my 62 Fury. I know I will need to use a different shifter., and have a drive shaft made. But my question is, How well does it fit ? And if you need to do work on the floor pan, and how much. Any pictures would help.

 

[Encswsm]

Holly has Transmission support adapters and some decent you tube videos. Apparently you cand pound the pan and trim some tabs from the trans. Check it out.

 

[rustytoolss]

Holly has Transmission support adapters and some decent you tube videos. Apparently you cand pound the pan and trim some tabs from the trans. Check it out.

I would like to. But unsure of where you found these videos link ???? also is this for 62-65 b body or general information ?

 

[493 Mike]

I have an A500 overdrive transmission. At some point I would like to install it into my 62 Fury. I know I will need to use a different shifter., and have a drive shaft made. But my question is, How well does it fit ? And if you need to do work on the floor pan, and how much. Any pictures would help.

I believe the upper half of the T bar cross member has to be rebuilt for clearance. So, it's a cut and weld project.
Mike

 

[rustytoolss]

I believe the upper half of the T bar cross member has to be rebuilt for clearance. So, it's a cut and weld project.
Mike

I was wondering about that. Something I did not want to hear. Thanks for the reply.

 

[Encswsm]

I didn't think the undercarriage was much different for mid sized Mopars. The Holly video is a 66 Charger and they say you only need to beat some clearance dents into your trans tunnel and trim a couple unused tabs off the transmission.