• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Another intake thread

the best intake I tried was the rpm performer and the next best was a stock intake ported by Wilson. the ch4b and the regular performer made no difference in performance over the stock 1969 intake. the street dominator killed low end torque and did help after 3500 rpms. all on mild built 440
 
The M1 dual plane is the aluminum version of the factory cast iron. The CH4B is considerably different in height, cross sectional area, and naturally, volume than the factory unit.
Learned something new Personally I’ve liked the old Muscle Hustle catolog recommendations and worked well on the day on the stock cars
The 71 intake is no slouch.

@BSB67 says no it’s not. So maybe someone else can confirm it is or it isn’t.

Well the whole point of this thread is to use the dual snorkel.

Then the factory cast iron is just as good.

I’ve been thinking about this option too. Might just go this route.

The 71 intake flows as good if not better than a performer.

I think a lot of you guys are missing the point that this 71 factory intake is the best flowing 440 intake Chrysler ever built. It ranks in the top 5 when put up against the others mentioned here. I wish I could find that comparison article with the dyno numbers.
There was a FB post maybe FAST but there was a post where someone tricked out the 71 iron intake and looked really impressive for a reworked iron factory intake
 
Last edited:
the best intake I tried was the rpm performer and the next best was a stock intake ported by Wilson. the ch4b and the regular performer made no difference in performance over the stock 1969 intake. the street dominator killed low end torque and did help after 3500 rpms. all on mild built 440
What was the et and mph of the unmodified stock intake and the CH4B?
 
The 71 Mopar intake has a center divider. The only difference I see between the 71 OEM and the CH4B is aluminum vs cast iron. The 71 probably flows just as good as the CH4B.

the best intake I tried was the rpm performer and the next best was a stock intake ported by Wilson. the ch4b and the regular performer made no difference in performance over the stock 1969 intake. the street dominator killed low end torque and did help after 3500 rpms. all on mild built 440

Learned something new Personally I’ve liked the old Muscle Hustle catolog recommendations and worked well on the day on the stock cars

There was a FB post maybe FAST but there was a post where someone tricked out the 71 iron intake and looked really impressive for a reworked iron factory intake

Sure but at what cost $$$ ?
Not an issue if the dual snorkel fits

What was the et and mph of the unmodified stock intake and the CH4B?
13.99 ET 100.1 mph vs 13.99 ET 100.2 mph. 67 Newport 4400 lbs with 2.94 gears
Sounds like the 71 intake is the solution to keep the dual snorkel.
What didn’t work? I was in the same boat. I insisted on keeping the dual snorkel air cleaner. It took a bunch of tries but I kept ordering different drop bases from Summit until I found a combo that worked. In the end I had to modify the one that I chose but not a big deal. Worked great
How did you make a drop base work on the stock dual snorkel? A drop base won’t drop the stock duel snorkel.
 
Back
Top