velozp
Active Member
Hello everyone while I had my circuit board for the instrument cluster on my bench, ( cleaning contacts) I noticed a dig in the copper etch going from the connector socket to the fuel gauge. ( the dig is about an inch away from the connector ) Something must have dropped on it at some point. My ohmmeter does show continuity from the socket pin to the fuel gauge terminal so the etch is not broken. Should I be over cautious even though this connection still shows continuity but some of the etch may be broken? Ive seen that this copper etch can be soldered. I am a electronics tech by trade so I could do it. Is their that much voltage on the board or should I leave it be? Thanks