fireguyfire
Well-Known Member
I’m just about ready for paint on my 69 charger after a full restoration. The car was rough when I started and I’ve replaced the rear frame rails, trunk pan, tail panels, and main floor pan as well as the torsion bar crossmember.
All is AMD metal which I’m very happy with.
The final things I need to weld in are the floor pan wiring harness covers which parallel the rockers.
I went through my “before” photos and realized that I didn’t take any good photos of how and where they should be installed.
As you all know there is a long and a short in each side.
Can anyone help me out with the orientation of how these should be installed with maybe a measurement or a photo so I get them in the correct factory position?
All is AMD metal which I’m very happy with.
The final things I need to weld in are the floor pan wiring harness covers which parallel the rockers.
I went through my “before” photos and realized that I didn’t take any good photos of how and where they should be installed.
As you all know there is a long and a short in each side.
Can anyone help me out with the orientation of how these should be installed with maybe a measurement or a photo so I get them in the correct factory position?
