Well I’ve sunk a ton of time in making these valve covers work! Had to put some clearance bumps in them on the exhaust side to clear the stage V rockers and valve springs. Sand blasted them and fabricated two wire loom tabs and welded them for the passenger side cover.
Then wrinkle painted them at least two times each to get them to wrinkle correctly and match
and after all that find out they are a mismatched set. No biggie right?well wrong.passenger side plug tube length is an odd length. So had to lengthen the tubes for that side 3/16” (the o ring recess isn’t as deep as the driver side one)
so finally they are all done! Here’s a few pics
Then wrinkle painted them at least two times each to get them to wrinkle correctly and match
and after all that find out they are a mismatched set. No biggie right?well wrong.passenger side plug tube length is an odd length. So had to lengthen the tubes for that side 3/16” (the o ring recess isn’t as deep as the driver side one)
so finally they are all done! Here’s a few pics