Knocking sound with manual trans

[Sam69sat]

Dimensions are on this page. If you need 4 speed parts, Brewers is the go to source for most of us. The owner is a member here and posts on 4 speed questions from time to time. @Dan Brewer

MAIN BEARING #308 3.543" DIAMETER - Mopar A833 4-Speed Transmission & Component Specialists

MAIN BEARING #308 3.543" DIAMETER

www.brewersperformance.com

 

[70CHRG]

Dimensions are on this page. If you need 4 speed parts, Brewers is the go to source for most of us. The owner is a member here and posts on 4 speed questions from time to time. @Dan Brewer

http://[URL]https://www.brewersperformance.com/product/b308-main-bearing-308-3-543-diameter/

[/URL]

Cant seem to access Brewers site. Not sure if their site is down.

 

[70CHRG]

Managed to get onto their site. That clarifies it thanks. Any search I did on a 308 bearing bought it up as a 40mm ID

 

[gkent]

Time to start talking "inches" and send Brewers an mail !!

 

[gkent]

Time to start talking "inches" and send Brewers an mail !!

How did you measure your bearing i.d. ? Did you take it off the shaft ??

 

[70CHRG]

How did you measure your bearing i.d. ? Did you take it off the shaft ??

No Measured the bearing

 

[70CHRG]

Time to start talking "inches" and send Brewers an mail !!

Ha Ha I knew someone would bring that up. I'm in NZ and moved to metric years ago. I know you guys are a little behind the times. Bearing has now been clarified. No doubt I will have more questions as I do the rebuild. I have emailed Brewers as I am looking at doing the overdrive conversion. Anyone here done it. My only concern as that the final drive won't be direct. If its going through the counter shaft and final gear being the one used the most would this be a weak point.

 

[gkent]

I know you guys are a little behind the times

Not me, I'm Canadian !!!