SOLD Lakewood Bellhousing

[hunt2elk]

Lakewood bellhousing for big block Mopar A/B/E bodies, block saver plate, pivot fork bracket, starter nose support cup, bell ball stud, bolt kit, and a z-bar that has been shortened to work. Compatible with either a 130 or 143 tooth flywheel. Was in a 67 B-body. $680.00. Pick up in west central WI 54727.

 

[Cranky]

How much? I don't remember......

 

[hunt2elk]

How much? I don't remember......

Fixed it. Now leave this one alone, lol. .

 

[Cranky]

 

[hunt2elk]

I'll be driving from WI to Englewood, CO (a suburb of Denver) middle of this week and could throw it in the truck if there is any interest from a member out in that area.

 

[hunt2elk]

$660.00

 

[hunt2elk]

Nobody needs a good bell housing?
$600.

 

[hunt2elk]

$575.00

 

[hunt2elk]

$550.00

 

[hunt2elk]

$525.00

 

[hunt2elk]

$500.00

 

[Moparpuller]

$500.00

Do you know if it will bolt to an np435 out of a truck? Thanks grant

 

[Moparpuller]

$500.00

Do you know if it will bolt to an np435 out of a truck? Thanks grant

 

[hunt2elk]

Do you know if it will bolt to an np435 out of a truck? Thanks grant

That I don't. I did have a guy stop over looking for a scattershield for a Dodge pulling truck he was building. He brought a template of the trans mount pattern, and this one wouldn't work for him. I don't remember what transmission he was using however. I could do some measuring if you tell me what you need.

 

[Moparpuller]

That I don't. I did have a guy stop over looking for a scattershield for a Dodge pulling truck he was building. He brought a template of the trans mount pattern, and this one wouldn't work for him. I don't remember what transmission he was using however. I could do some measuring if you tell me what you need.

Ok thanks. Will try and get some measurements this week and check back