Newb question: How do you remove a 68 440 exhaust manifold?

[68 Chris]

Kroil

Check them out@ www.Kanolabs.com or e-mail them@ Sales@Kanolabs.com

Supposedly they only sell to commercial ventures, but that's pretty liberal as to what a commercial venture is And about every 2-3 months I'll get a flyer from them telling me what is on special, and although it's still relatively expensive, just a little works, so in the long run, it's cheaper. Aerokroil or Silikroil

Also, the Hardware store in my neighborhood carries it. So if you can't get your hands on it just let me know and I'll send you a can in the mail.:spam1:

 

[D575]

BuckNeccid is correct!
Kroil is the best penetrant. I work at Edwards AFB CA. That stuff is used extensively.

Kroil is the shizzit. We used it at the Power Plant I used to work at, it's amazing stuff. The Oil That Creeps.

 

[sublimegtx]

Not tryin to hijack this thread, but found this on fabo about penetrating oils
One of my cruisin magazines I get had a short article on penetrating oils.

The results were reprinted from Machinists Workshop Magazine on how
much torque was required to remove a nut from a "scientifically rusted" enenvironment.

No oil.......516 pounds
WD-40.....238 pounds
PB Blaster....214 pounds
Liquid wrench...127 pounds
Kano Kroil........106 pounds
50/50 mix of ATF & Acetone...53 pounds

Never tried it myself, just passing it along.