Oil pressure sender

[sstocker31]

Where is the oil pressure sender supposed to be located?

68 Charger / 440......

 

[67 coronet]

back of engine,at firewall.almost right in the middle.

 

[sstocker31]

Thanks for the reply....There are two plugs back there, is it supposed to go on the driver side, or on the passenger side....

I'd be lost without you guys......Thanks again

 

[Meep-Meep]

There are usually two holes, one may be a 1/4" pipe and the other is an 1/8" pipe. It goes in the 1/8" pipe hole and I think that faces the drivers side. It really doesn't matter from a pressure reading perspective since it's the same oil galley, so just make sure the wire reaches wherever it ends up.

 

[Grabinov911]

Direction

There are usually two holes, one may be a 1/4" pipe and the other is an 1/8" pipe. It goes in the 1/8" pipe hole and I think that faces the drivers side. It really doesn't matter from a pressure reading perspective since it's the same oil galley, so just make sure the wire reaches wherever it ends up.

Factory, it leans toward the driver's side of the car - so that standing on the driver's side you can see the terminal on top. Not that it makes much difference as Meep said.

 

[ChgrSteve67]

 

[sstocker31]

Thanks for the replys guys......Yes mine had a 1/8" npt on the left side, and 1/4" npt on the right. the sender went in as pictured above.