pturner
Well-Known Member
- Local time
- 9:34 AM
- Joined
- Jul 17, 2011
- Messages
- 248
- Reaction score
- 153
- Location
- Morristown, Tennessee
My 1968 Roadrunner is a hardtop car (no post). The rear inside window top metal trim panels (where you attach the fuzzies) have a slight curve to them with a larger curve at the back.
I have a fuzzy set with the rear larger upward curve, but the rest of the fuzzy is straight. Does anyone know if someone makes a set of of the slightly curved fuzzies? The small metal plate the fuzzy is made on will not bend. Do I notch the metal backing fuzzy plate to try to bow (bend) the fuzzy to match the inside seal trim plate? Anyone else had this issue?
thanks all
PT in Tennessee
I have a fuzzy set with the rear larger upward curve, but the rest of the fuzzy is straight. Does anyone know if someone makes a set of of the slightly curved fuzzies? The small metal plate the fuzzy is made on will not bend. Do I notch the metal backing fuzzy plate to try to bow (bend) the fuzzy to match the inside seal trim plate? Anyone else had this issue?
thanks all
PT in Tennessee