So which are decent OEM-type motor and transmission mounts?

[Mebsuta]

Which are decent OEM-type rubber motor and transmission mounts?

I used an Anchor transmission mount my RR, but I am hearing bad things. The other choices are DEA and Westar. What's something that will act about like original without spending $100 on a block of rubber and steel? I don't drag race; just cruise my old beater around. Thanks.

 

[MarPar]

Used these for my 68 GTX (440cid) they're pretty nice, and didnt break the bank!!

http://store.440source.com/Engine-Support/products/27/

just put them in this year, so i cant tell you the longevity yet.

 

[5.7 hemi]

Poly loc's from shumacher, and they are pricey, but the last mount you'll ever need!! If you look at the bolt that goes thru the mount and k frame, you'll notice that it is a 3/8 bolt, shumacher uses a 1/2 inch grade 8 bolt. Also, with the 3/8 bolt, you can watch the engine lift to the passenger side, not so with the 1/2 inch, and that lost torque due to engine rock is now going to the tires....just something to think about. Get the urethane trans mount also.

 

[67 coronet]

anchors are cheep std mounts,but really about the same as the originals.they will work for stock aplications for crusing,but will break just like the stock mounts.