• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

WTB Wanted: spring steel washers for vent window handle

Status
Not open for further replies.

Richard Cranium

FBBO Gold Member
FBBO Gold Member
Local time
4:32 AM
Joined
Feb 20, 2012
Messages
59,234
Reaction score
204,708
Location
Maskachusetts
Feedback: 25 / 0 / 0
As pictured below. Handle retaining pins needed also …. two of each.

Or, I’d take two complete junk lower vent window channels.

:thumbsup:

IMG_8431.jpeg
 
Last edited:
I'll bet you can buy spring washers from the local hardware store. Perhaps pins too. Look at nails, they are soft enough to peen in place.
Mike
 
I'll bet you can buy spring washers from the local hardware store. Perhaps pins too. Look at nails, they are soft enough to peen in place.
Mike

Thanks, but I checked the local Ace hardware store and no go.
 
How about the ones between the brake shoe and the park brake actuator pin?
 
I've got all that stuff...are you still in need? I'm stripping down a set of wasted vent window assemblys
 

I believe the vent window pivot shaft is 5/16 which is .312... The hole in these wave washers is .330

The pin is a roll pin... I don't know the dimensions...

 
Status
Not open for further replies.
Auto Transport Service
Back
Top