Window clips with vinyl top?

[dodge68charger]

Are the window clips around the front and rear windows mounted the same height as the non vinyl top cars?

I think i held the clips lower about an 1/8 inch when i had to drill new holes

 

[davek]

I would say they are at the same spot.

 

[dodge68charger]

Thank you

 

[dodge68charger]

I marked the locations. Just not sure on the corner hole locations. One says 4 1/4’’ from the bottom corner, one says 5’’and my parts charger looks like its at 4’’ lol

Should the clips sit flush at the bottom or a bit lower is Ok?

Thank you

 

[davek]

I marked the locations. Just not sure on the corner hole locations. One says 4 1/4’’ from the bottom corner, one says 5’’and my parts charger looks like its at 4’’ lol

Should the clips sit flush at the bottom or a bit lower is Ok?

Thank you

View attachment 1972949

View attachment 1972950

View attachment 1972951

I can take pics tomorrow for you. Need anything special?

 

[davek]

Thread 'Rear window SS trim install - '69 Charger -- clip locations ?'

Jun 29, 2021

Hi all..

I'm looking to drill the holes to mount the rear window SS trim clips, but not quite sure of the locations.

I went through the threads and come up with the following locations...

How does this look ? What about the lower corner clip locations -- does this look correct ?

Thanks ! Jack...

• Jack Parmentier
• Replies: 12
• Forum: Exterior Body, Paint, Trim, Chrome

 

[dodge68charger]

Just clip heights on the sides/bottom and where you measured from on the corners. Top holes were already there

Thank you!