Exhaust Tips

[D1esel]

Just removed a fuel cell from my 67 coronet trunk and reinstalled an original fuel tank and plumbing. I then installed the correct tail pipes along the tank. My exhaust outlets are about 5 or 6 inches below my bumper. Is this normal?

 

[dadsbee]

No...

 

[D1esel]

No...

Can you tell me what is? I can't raise the pipes higher as they will hit the tank

 

[dadsbee]

@Jerry Hall is the resident expert on '67's... but here's my '66 Plymouth.

 

[D1esel]

@Jerry Hall is the resident expert on '67's... but here's my '66 Plymouth.
View attachment 1944965

Thanx,I see your pipes rise after the tank then curve down. My pipes are straight through

 

[Jerry Hall]

These are NOS tailpipes. They look just like @dadsbee tailpipes to me.

 

[D1esel]

These are NOS tailpipes. They look just like @dadsbee tailpipes to me. View attachment 1944988View attachment 1944989

Oh,thank you. I was sold mine as being oem correct. I guess not. To get mine to tuck up under the bumper I found a ford tail pipe extension that looks like it will curve up enough to accomplish that. Thanx everyone for the pics, and comments. Most appreciated.

 

[71RRHI]

My 67 is not stock, but any exhaust tip the hang 5" below the bumper would look weird.

 

[Runner 68]

My 67 is not stock, but any exhaust tip the hand 5" below the bumper would look weird.View attachment 1945068View attachment 1945069

Agree, but your tips look a little on the short side. They should stick out a bit past the bumper.
68 below.

 

[71RRHI]

I have them at 1 3/4 inch below the bumper. And the leading edge of the stainless tip is even with the lower edge of the bumper. I did it that way cause that's the way I liked them. Looks different from different angles. Yours look good.