hopman
New Member
not suprising the carb needs attention. while disassembling I noticed theres no air fuel needle heads. the big hole centered is the pcv port. the 2 lower ports were plugged (I was able to get them out). where I believe the adjustment needles should be, theres solder. if I flip the base I see what I believe are the tips of the needles sticking out of the ports. I believe the needles are broken off.
am I correct? asking before I attempt to remove these and more than likely ruin the original base plate.
thank you very much.
the carb tag reads. 4429s
59 38
aboard. You might try posting your questions in the proper forum. Go to "search forums" and you can find the different areas to find info. Good luck on your rebuild.
