Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I want to pull the oil pan (8 quart Milodon) from the 440 in my 66 Belvedere and change the gaskets. Can I pull the pan without having to pull the motor up? The car will be on a lift so there will be plenty of room under there to maneuver, but I'm wondering if it will clear. Thanks, chris
I'm getting ready to order a larger fuel cell for my Belvedere and I want to order one with a sending unit so that I can have a gas gauge. The wire that went to the original gas tank seems to be under the car still and I want to make sure it works before I order a fuel cell with a mopar sending...
Hey guys, how far should the snubber be from the body? My 66 Belvedere that I am taking off of the track and returning to street duty has the snubber actually touching the body while sitting still. This can't be good! I'm guessing that they did that for racing use as it might make sense for...
I'm converting a 66 Belvedere race car back to street duty and I'm wondering what I need to do as far as crankcase ventilation. The car has a 440 in it and the PO had hoses that ran from the valve covers down to a bung on each header. I'm changing valve covers and headers and no longer have that...
This should be an easy one... I'm installing power steering on a 66 Belvedere that was born with manual steering and I need to know what I need to order as far as pulleys are concerned. I have a 440 going back into the car and it had a single belt pulley system with an under drive pulley on the...
I'm trying to install a new blower motor and my squirrel cage is rusted onto the old motor shaft. I think I can cut it off and salvage the metal plate that it's attached to, but the blower motor wheel is gonna be trash. Anybody got one?
thanks,
chris
Hey guys! I just replaced my 4:30 spool with a 3:55 posi. When I install my Moser axles with what I'm assuming are green bearings, the axles are hitting in the middle. If I tighten up one side, it is actually pushing the other axle out! Is that steel plate in the middle of the center section...
Does anybody have the NAPA part number for the u-joint that fits the big yoke on one side and the small yoke on the other? My NAPA guy thinks I'm crazy.
thanks,
Chris
Hey guys! I just found this forum and thought I would give you guys a try for some stuff I need. I recently purchased a Belvedere 2 race car that I'm gonna convert back to the street. I need a lot of the stuff to make the windshield wipers work. I have a motor, ( not sure if it works not...) but...