Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Just wondering if anyone has ever seen a 67 R/T with the stripe under the doors? I was told it could be a preproduction stripe.
Any info on where to possibly get that stripe would be appreciated.
Just wondering if anybody in here has bought the 12 point intake bolts from 440 source? I know the factory bolts are good enough, but I wanted something a a little fancier.
So I had a chance to take the car out today. Cruising along and stab the throttle it still stumbles like a blubber but once it catches up. It gets up and goes. But if I'm cruising and dont stab the throttle, but do it in a way that opens the throttle somewhat quick it doesn't stumble. I have 37...
Looking at either a clean agent fire extinguisher or a dry chemical fire extinguisher? I really don't want to spend a lot of money, but want to make the right choice on a fire extinguisher. Anyone have some good feedback?
Should the inner carburetor mounting holes be left open or be plugged? I noticed the left rear inner hole had some black soot around it like it had a vaccum leak. 440 single plane M1 intake.
I'm wanting pictures of how the battery is mounted in the trunk on W023 cars. And how the battery cables are ran under the car to the engine compartment.
Is there supposed to be a rubber grommet where the throttle cable passes through the firewall? Anyone got pics? Does the clip go on first to hold the cable in place then the grommet?
I'm getting a factory throttle cable for my 67 coronet, I know its been discussed in here before. But I was wanting to know if anyone has actual pictures of the retaining clip and grommet. I don't see the clip in the car. Is it behind the grommet?
Looking to get valve cover studs for cast aluminum valve covers and iron heads on a 440. Some stud kits come with washers, will they work with the small bolt hole area? What length stud would I need? Thanks for any help.
I broke a seat bracket bolt and was wondering what's the best way to get the swedged part out of the square hole? And does the new bolt need to be swedged on? I don't want to bend the seat track.
So I've put led bulbs in the parking lights and taillights of my 67 coronet. Turns wont come on with the factory flasher, so I bought a no load flasher. Right turn signal works. Left turn signal works but both parking lights flash at the same time. Put in a new flasher with a ground wire in...
On a 67 coronet, where's the turn signal flasher located? I've been told behind the ignition switch or under the glove box area. If anyone has a picture of its location that would be great.
I need to flush out the fuel system. I don't have a air compressor and I do not want to take the fuel cell out. Can I just run fresh gas through the system?
I got a new 2 5/8 sport comp fuel pressure gauge, its got a bigger fitting on the back of the gauge that hooks up to the #4 braided line. Is there a 90° fitting i can screw into the compression fitting on the gauge?
So I have a autometer fuel pressure gauge mounted on the cowl. I had to take the gauge out of the gauge cup to put a bulb in it. Upon putting everything back together I noticed the gauge needle moving by itself. When I turned the fuel pump on, the needle went higher than what it was set at. Has...