Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Hi
Do I need to drop the tank to change the sending unit. Its tight with rear right there. Or can I jack up body and left rear and spring drop to get to sending unit?
hi
just got my car back on road. new b&b clutch. and overcenter spring is installed under dash
Shifts great.
The clutch pedal doesnt come all the way back up
Is there an adjustment?
Hi
my 69 runner with 383
I have rebuilt stock carb, new distributor with petronix, new coil and carb has fuel
The past few drives car felt a little sluggish like no power at times
Then the other day I started it drove a few hundred feet and it died
Has fuel in carb
Dont know what it could...
hi
i happen to kink the vent line above the tank. the car started and ran for a min and died.
I realized the vent line was kinked
I fixed the line and tried starting car but it didn't want to start. I did smell fuel in carb so fuel is getting there
I opened gas tank cap to let some air in the...
Hi
is this the correct oreintation of the sending units. The tank is keyed so it can be installed like this or upside down
In this orientation you will see that the vapor tube would be closer to the top of the tank
Hi
I resembled the tank and lines for the 440. Got a fuel leak by tank.
This is picture of the back of tank.
Is this the correct orientation of the vapor line and fuel line? My vapor line is lower then the fuel line. The car runs fine just saw fuel on floor under tank. looks like it may be...
I put in a 3 speed wiper switch which was rebuilt and tested fine.
The wiring harness under the dash is new. I just put it in
The wiper motors was just rebuilt and i just put it in
When I turn it on the wipers they moved a little and stopped
Then with the wiper switch in off position I heard...
hi
Can someone tell me what type of screw holds the back seat (back vertical seat) to the sheets metal frame between the seat and trunk on a 1969 convertible roadrunner
There is a screw per side. Don't know if its a hex head or large Philips. there is also no clip in the frame of car . there...
Hi
For 1969 charger. Need to adjust the door strike a little. The door needs to be pulled up a hair to make it close perfectly. Do you adjust the strike/latch? if so how is it done
Thanks
Hi
Can anyone tell me where the (4) furthest right stainless trim pieces go? I cant remember. The two to the far left are the belt moldings on top of doors
Question
I cleaned and prepped sun visors. Added bulldog adhesion promoter. Let setup 15 mins or so
then sprayed paint
Did this a few months ago. Kept them in warm room
they are still a little tacky
what could it be
strange
Hi
Im
Installing the plastic dust sheets on interior of doors before I put on the door panels
It was installed with some white caulk or butyl tape
Anyone know what it is
Can anyone recomend a wrinkle paint for the 1969 air cleader. It not a solid black from what I researched more grey /black
See photo attached of what i found
Hi
Anyone have a good close up picture of what the grey painted surface on these wheel covers looks like. Im restoring them and know they were painted a grey, Just dont know what grey. Some people say its argent grey like the grill
Thanks