448 Cubic Inch Trick Flow build

[69 GTX]

Yippee!!!!

 

[Hemirunner]

Yippee!!!!

It’s only been 3 years lol. I’ve got everything now with the exception of the solid roller cam and some pushrods. I’ll need to see if I can find a great deal on something similar to what I’m looking for.

 

[wingcarenvy]

It’s only been 3 years lol. I’ve got everything now with the exception of the solid roller cam and some pushrods. I’ll need to see if I can find a great deal on something similar to what I’m looking for.

Right on! I cant wait to see this one run.

 

[Budnicks]

 

[biomedtechguy]

Finally got a few parts gathered up.

View attachment 1239322

Congrats, and I am learning about parts being difficult to get. My builder selected the same ring and crank manufacturer for my build, but Diamond for the pistons, which should arrive a good bit before the Molnar crank and rods.

 

[Hemirunner]

Congrats, and I am learning about parts being difficult to get. My builder selected the same ring and crank manufacturer for my build, but Diamond for the pistons, which should arrive a good bit before the Molnar crank and rods.

I’m a Diamond MWD but the cost of Diamonds vs these ICONs is substantial. This engine is stock stroke and no power added planned or needed.

 

[biomedtechguy]

I’m a Diamond MWD

I'll take that as a "stamp of approval"

 

[Hemirunner]

So…… five years later and there’s hope in sight. It’s all together with the exception of rockers and pushrods.

 

[69 GTX]

Yeah!

 

[Hemirunner]

Need to load in the roller lifters and measure for pushrods…

 

[Budnicks]

So…… five years later and there’s hope in sight. It’s all together with the exception of rockers and pushrods.

Great news, damn, didn't relies it was 5 years ago

we'll need a report & maybe photo & video after it's running

 

[Hemirunner]

Great news, damn, didn't relies it was 5 years ago

we'll need a report & maybe photo & video after it's running

The shop I used to dyno at sold, and the new owner went out of business so I’m struggling to find a shop to dyno at. It might be a little bit….

 

[Budnicks]

The shop I used to dyno at sold, and the new owner went out of business so I’m struggling to find a shop to dyno at. It might be a little bit….

That sucks, good luck with that...

 

[oldkimmer]

Glad u can see the light at the end of the tunnel. Kim