Hemi2Much
Well-Known Member
I dropped the engine off to start the machining process yesterday.
The machinist said .030 over should clean the cylinders up.
Crank, rods, & the rest of the block looked good but will know more once fully checked out.
I'm going through the pile of parts trying to locate everything that was on the car.
Wondering if you guy's can help me out verifying some of the random parts I'm unsure about.
# 1 7 blade, 5 rivet, aluminum blade clutch fan. Prt # 912773-SC A66
# 2 Flex plate I believe the one on the right is correct.
# 3 Transmission Cooler....
The machinist said .030 over should clean the cylinders up.
Crank, rods, & the rest of the block looked good but will know more once fully checked out.
I'm going through the pile of parts trying to locate everything that was on the car.
Wondering if you guy's can help me out verifying some of the random parts I'm unsure about.
# 1 7 blade, 5 rivet, aluminum blade clutch fan. Prt # 912773-SC A66
# 2 Flex plate I believe the one on the right is correct.
# 3 Transmission Cooler....