• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Another camshaft break in question

hoover

Well-Known Member
Local time
7:54 PM
Joined
Aug 3, 2017
Messages
224
Reaction score
247
Location
taylors falls mn
Was there a break in procedure on the assembly line when these things were built?
 
I went through a Ford plant when I was young in the 60's and they just fired them up at the end of the assembly line and drove them outside to the parking lot.
 
Pontiac fired them up before they were in the car and then again after they were installed in the car. No 2,000 rpm for 20 minute stuff. But they also had better lifters and oil designed for flat tappet camshafts. I would be willing to bet Mopar followed a similar procedure.
 
Capture+_2022-12-08-18-44-45~2.png

I'm going to say yes.
 
Auto Transport Service
Back
Top