On the search for a right front fender top piece of trim for my 66 Satellite which will apparently take awhile.
The trim appears to have been bumped up by the turn signal bezel that apparently cracked and split it along the top about an inch and half to two inches. It was all squeezed together (no gap or crimp in the aluminum) and isn't readily apparent except for one side has an outward dent apparently from the front retaining clip when it was bumped off to the side.
Question - can a trim restoration shop successfully weld this light weight aluminum trim successfully? If so that may be a lot easier than finding another good one.
The trim appears to have been bumped up by the turn signal bezel that apparently cracked and split it along the top about an inch and half to two inches. It was all squeezed together (no gap or crimp in the aluminum) and isn't readily apparent except for one side has an outward dent apparently from the front retaining clip when it was bumped off to the side.
Question - can a trim restoration shop successfully weld this light weight aluminum trim successfully? If so that may be a lot easier than finding another good one.