Looking to see what you guys are running for driveshaft loops. BTW I'm running full 3" exhaust.
Same one I have, had 3” exhaust dumped at the axle, now headers with 3.5” extensionsView attachment 561395 I just have one of these
Get this one. Trim it and weld together instead of bolts.View attachment 561395 I just have one of these
That’s what I did when I installed it.Get this one. Trim it and weld together instead of bolts
I wouldn’t run either on the street but that’s just my preference. I can’t justify the price of CF nor do I like the way they explode when you hit anything with them and I’ve bent the aluminum shafts but I’m pretty hard on ****.DVW looks tight between the driveshaft & exhaust. How much clearance do you have? I'm thinking of either a carbon fiber or aluminum drive shaft. The carbon fiber needs to kept away from heat of 200 or higher if I remember correctly.
Mike what do you run in your green car?I wouldn’t run either on the street but that’s just my preference. I can’t justify the price of CF nor do I like the way they explode when you hit anything with them and I’ve bent the aluminum shafts but I’m pretty hard on ****.
Mark Williams chromoly with 1350 u-jointsMike what do you run in your green car?
I have something like this just in T6 either 6061 or 7075 Alum
I can't remember which alloy
{IIRC it was from Pro Aluminum Products, not sure they're still making them,
I purchased a couple of them 10+ years ago, I'll get a couple photos of it & post it a bit later}
this is one from Mancini Racing below Like $179 {steel} IIRC
not cheap but a bolt on
not my car
View attachment 561540
another look at the parts
View attachment 561541
View attachment 561542
I bought the cheap $20. kit from Jegs. Modified it with welds instead of the bolts, and anchored it to the seat studs.
View attachment 561666