JR_Charger
Well-Known Member
I tried installing PST's polygraphite bushings and this is as far as I could get -
- which is no progress at all.
This guy's bushings pushed in by hand -
But I couldn't drive mine in with a sledgehammer (granted, I had to use the sledge one-handed but still . . . ). The hammer either bounces off or the bush pops off to the side or goes in at an angle and gets wedged in place.
One of the comments to the above video mentions using a vice. My vice isn't big enough for this. I think a press would work better anyway, but I don't have one of those either.
I'm open to any clever solutions the forum has to offer.
- which is no progress at all.
This guy's bushings pushed in by hand -
But I couldn't drive mine in with a sledgehammer (granted, I had to use the sledge one-handed but still . . . ). The hammer either bounces off or the bush pops off to the side or goes in at an angle and gets wedged in place.
One of the comments to the above video mentions using a vice. My vice isn't big enough for this. I think a press would work better anyway, but I don't have one of those either.
I'm open to any clever solutions the forum has to offer.