- Local time
- 1:16 AM
- Joined
- Jun 12, 2012
- Messages
- 35,614
- Reaction score
- 95,932
- Location
- NZ - just short of the South Pole
So, I took on board some discussion a while back about the oil temperature being just as important as the pressure....as well as general water temperature.
I have a small sweep Autometer gauge (matches a few others) and was wondering where you guys fitted the bung for the sender unit. The instructions say to weld or braze a bung in the pan, but is there another suitable location?
Just asking before I go and do something crazy or expensive or unnecessary.
This is for my 1968 Dodge A100 with the 360 block.
Thanks.
I have a small sweep Autometer gauge (matches a few others) and was wondering where you guys fitted the bung for the sender unit. The instructions say to weld or braze a bung in the pan, but is there another suitable location?
Just asking before I go and do something crazy or expensive or unnecessary.
This is for my 1968 Dodge A100 with the 360 block.
Thanks.