• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

My Hemi on the Dyno

6PKRTSE

Well-Known Member
Local time
1:25 PM
Joined
Nov 15, 2010
Messages
3,247
Reaction score
5,694
Location
Motor City
I know it is not for a Charger (B Body) but figured it still may be worthy. Here is a link that my buddy sent to me with my Hemi that is in now in my 70' Challenger on the dyno. Let's see if this works.

 
Nice! What did it make?

It's going to be a No E.T./Grudge car at first. Lets just see how she does with all of the Nitrous first. Then most will be able to figure out what is is estimating. The main thing for me is, it is only 10.5:1 pump gas engine and I can still drive it back & forth to work, cruises nights, etc on the street also.
 
sounds nice

thanks for sharing

I'm curious to also see the what kind of power & torque it made
with no power adders 1st, then what it does with what system {?}
on a 10.5:1 compression build

Roush built {?}
 
sounds nice

thanks for sharing

I'm curious to also see the what kind of power & torque it made
with no power adders 1st, then what it does with what system {?}
on a 10.5:1 compression build

Roush built {?}

Lets just say it is more than it looks. Well, then again all of those solenoids sure do make it look fast.
That is where I work. Yes, I built it & dyno'd it here with the help of many co-workers.
 
Lets just say it is more than it looks. Well, then again all of those solenoids sure do make it look fast.
That is where I work. Yes, I built it & dyno'd it here with the help of many co-workers.

I know some was left on the table by keeping it street friendly. I am sure with 15.5:1 pistons, more rocker arm ratios & bigger grind spec nitrous cam we could of picked up another 150+. It made more on motor only than was expected since it is has a nitrous spec cam.
 
Still haven't seen a post with the actual results/numbers?
 
That rocks Jay, can't wait to see it at a cruise night around town.
 
Bad *** motor!! Any chance you could Get me a measurement of the intake height from the top of the plenum to the bottom of the valley?
 
Bad *** motor!! Any chance you could Get me a measurement of the intake height from the top of the plenum to the bottom of the valley?

Yes, I can get that measurement for you next time I go out in the garage.
 
Yes, I can get that measurement for you next time I go out in the garage.

If case you were wondering if it will fit under you hood or not. I do have this picture with a measurement across the top of my fenderline with a straight edge. Nope, sticks approx 4-1/2" above the fenderline. Going to need a scoop.

20151003_144209.jpg
 
I have a decent size scoop, more trying to figure out how it related to my crossram. Wanted to see if I could squeeze air cleaners on it with the hood on.
 
I know it is not for a Charger (B Body) but figured it still may be worthy. Here is a link that my buddy sent to me with my Hemi that is in now in my 70' Challenger on the dyno. Let's see if this works.



Yah that's sounding very nice ...
 
Auto Transport Service
Back
Top