Let's see some engine shots !

black64 · Dec 15, 2021

Snook · Dec 15, 2021

black64 said:
View attachment 1208144

clean!

Chuck

early2drsedan · Dec 15, 2021

Fast Savoy said:
Does anyone have one of these fender apron's? I am in need of one!

View attachment 1207254

those are really rare also the part goes between the inner fender amd firewall is different and they where only used on 64 dodge max wedge cars

Big bill · Dec 15, 2021

My old engine

Rat Rod Al · Dec 15, 2021

rad savoy · Dec 16, 2021

Outlawd · Dec 17, 2021

Outlawd · Dec 17, 2021

65Bel · Dec 20, 2021

493 Mike · Dec 20, 2021

I installed the front drive system on my 540.
Mike

65Bel · Dec 20, 2021

65Bel · Dec 20, 2021

Fast Savoy · Dec 21, 2021

early2drsedan said:
those are really rare also the part goes between the inner fender and firewall is different and they where only used on 64 dodge max wedge cars

I still have the piece on the firewall. The fender apron was chopped out for headers. Are you sure Max Wedge only apron?

Thanks for any info Ed

early2drsedan · Dec 22, 2021

Fast Savoy said:
I still have the piece on the firewall. The fender apron was chopped out for headers. Are you sure Max Wedge only apron?

Thanks for any info Ed

yes 100%

Builderguy · Dec 22, 2021

Dave6T4 · Dec 22, 2021

426 Street Wedge with Chrysler 300H 2 X 4 setup in a1964 Polara 500 I used to own.

Dave6T4 · Dec 22, 2021

440 dressed up as a 426 Street Wedge in my 1964 Canadian Polara hardtop. Big blocks were red in Canada in 1964, so that is what I did. Edelbrock 750 cfm carb on painted Edelbrock aluminum intake, "452" heads, and Mopar Performance repro Magnum cam.

Mackman · Dec 22, 2021

Just fresh.

Canadian1968 · Dec 22, 2021

This is a picture from the end of the summer . It is currently going over a make over.....

33 IMP · Dec 22, 2021

Fast Savoy said:
I still have the piece on the firewall. The fender apron was chopped out for headers. Are you sure Max Wedge only apron?

Thanks for any info Ed

The pic you referenced is one of maybe ten on the planet that had those factory iron tri-y headers. If you just want a panel to repair the cutout for fenderwell headers, that shouldn't be too hard to find.
(Those headers in your Pic are about $15,000 a pair, yep, just the manifolds.)

Let's see some engine shots !

Well-Known Member

FBBO Gold Member

Well-Known Member

FBBO Gold Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

FBBO Gold Member

FBBO Gold Member

FBBO Gold Member

FBBO Gold Member

Active Member

Well-Known Member

Builderguy

FBBO Gold Member

FBBO Gold Member

FBBO Gold Member

Well-Known Member

FBBO Gold Member

Similar threads