Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I am just getting into installing headlite buckets---The components were restored at a shop years ago upon original dissasembly---one of the motor switch is marked as being bad---any source for these????
Still looking for some vent window pivot pieces for 67 Charger/Coronet--also need a side window same car--will have to double check which side--67 fender splash shields??
I have a fairly trashed heater box that I have refurbed--but is missing the bracket that holds the cable right above the defrost openings--for a B body non air--1967 car. Any one got pieces of heater boxes--I guess if I had a pic and measurements I might could bend a piece of metal up to do the...
I have my vent windows together--still need the actual windows though!!!--the end of the long chromed piece that looks like a wrench---does it rest on something---my doors to not have anything in that spot---are they special bolts that bolt to the door and extend inside the door???
This may seem like a no brainer question but here goes---when I dissasembled the charger I took the leaf springs apart--blasted/powdercoated and reassembled---I took care to mark LEFT vs RIGHT pieces---Reassembled got it all back under the car---the left spring causes the rear shackle to swing...
Still a little confused on my window situation--I keep going back and forth with whether I have the correct parts for this car or not. Should the side window have a 45 degree cut at the top leading edge??? I have a package of window glass wrapped up and labled for my car but the quarter windows...
Are the side/door glass specific to charger in 67??? And does anyone have some. I need both right and left-------never mind---My lack of Mopar savey hits me every day--I was looking for something that looked like the quarter glass---i.e. it has a large metal piece with the glass that rollers run...
I seem to be missing the driver side back edge of the vent window frame--same part that front edge of the side glass would run in. Are they the same on chargers as other B bodies?? Anybody got one???
Evidently my project charger with boxes and piles of parts did not include the headliner board---any available (in Georgia)?? or I hear some talk about using a "bow" system---My car does have some holes along the inside roof edge that look like spots for "bows"--Any suggestions appreciated
Lots of posts on this subject but I could
not find this answer. I recieved my new windshield gasket and I installed it in the opening just to see how it fit. It goes onto the pinch weld fine on the top and sides but it then has to transition on to the bottom where the pinch weld is not part of...
I am new to the forum and new to Mopars. Getting into a rotisserie resto on a 67 charger. I need peace of mind on these frontends---The lower control arm has a pivot shaft and bushing that I pressed out. I believe I have the poly replacement bushing so I left outer shell in place. So I guess I...