Brass oil pressure line secure
- Thread starter o1gnah
- Start date
That line is set in length. You use the fittings and route the line as needed.
Keep line pushed in as you tighten and don't overtighten. No welding, it has a compression fitting to seal it. Those look like they are already seated.
72 inch is a very long line.
Not compression. Tapered seat.
Yes compression fitting. It compresses on the line and doesn't come off.
You cut the line to length. Put the nut on the line, put the ferrule on the line and both it together.
You cut the line to length. Put the nut on the line, put the ferrule on the line and both it together.
Never seen a kit with soldered ends before.
Me neither maybe its just the way they packed it. You would end up with allot of coils.
Look at the picture. The line is pre-terminated. There is no compression ferrule.
Try this kit. You can cut the line to length. Equus E9901 Equus Mechanical Oil Pressure Line Kits | Summit Racing
You could do that with any copper line and brass fittings if wanted, but there is really no need as good compression fittings seal up good and normally don't leak. Somebodies just trying to make extra $ as the Summit kit has 6 Ft of line in it too, which you can cut to the right length and install for about half the price.
Similar threads
