Rear End getting some love

[Bigfoots N Mopars]

Super Beat should be back on her wheels by next weekend! Then it’s subframe connecters and roll bar...might not be driving this season, but dang i’m Stoked. The engine, and fab work are being done by local racing legend Gary Hedden of Magnum Superchargers out of Cedar Mn.

 

[Bigfoots N Mopars]

Here are some of his old cars, and a Henry J Gasser that’s getting a Blown 392 Hemi

 

[Bigfoots N Mopars]

The Henry J

 

[Bigfoots N Mopars]

The Hemi Challenger he used to race.

 

[khryslerkid]

Thought you were talking about your Buttocks

 

[Budnicks]

should be cool, when done
more meat (as in tires, totally nonsexual) is always nice

what size rear wheel & tire are you going to ?

 

[JackpotJim]

I can remember seeing the challenger run division 5 points meets back in the late 70's.

 

[Gpuller]

"Rear End getting some love"

 

[WP29440SE]

I'm glad this thread is on a car site !

 

[Bigfoots N Mopars]

I can remember seeing the challenger run division 5 points meets back in the late 70's.

Later the car was painted black and purple like the Hemi in the pick.

 

[biomedtechguy]

what size rear wheel & tire are you going to ?

X2??

 

[Bigfoots N Mopars]

X2??
View attachment 821196

There is Almost 17” of clearance with mini-tubs. I’m out of town right now. Next week I’ll take some more pics. I’m looking at running Hoosier 29.5x11 15 slicks with 15.2 section width. This pic is the 295/65r 15 13” section width on 15x10 5.5 backspace on the 70 Satellite Wagon he did before my car. He narrowed My Dana 60 1inch each side.

 

[6PKRTSE]

Did this on my Challenger also. Mini tubbed it to the frame rails and narrowed the Dana 60 to fit. Now I can fit a 315/60/15 Drag Radial or 29.5X10.5W slick. Also went with spool, 40 spline gun drilled axles.

 

[Bigfoots N Mopars]

Did this on my Challenger also. Mini tubbed it to the frame rails and narrowed the Dana 60 to fit. Now I can fit a 315/60/15 Drag Radial or 29.5X10.5W slick. Also went with spool, 40 spline gun drilled axles.

View attachment 826132

You have more pics of the car?

 

[6PKRTSE]

You have more pics of the car?

It's almost done. Down to electronics and wiring the whole car. Also working on the super shaker to fit the dual Dominators and tunnel ram. Will still seal and function like the factory shaker when done.

 

[Bigfoots N Mopars]

That is BAD ***, love the Shaker!

 

[Bigfoots N Mopars]

The narrowed Dana is just waiting for disc brakes, but perches are welded in. Spring relocation is done waiting to finish welding in the mini tubs. Can’t wait to mock up the rear end! And sit the car on the ground.

Oh yeah, I installed super stock springs On my Satellite. So I’ll be able to compare to Caltracs on the Coronet.

 

[Bigfoots N Mopars]

Subframe connectors, mocking rear end up