Jesse, do you have a pic of yours without the end caps on? Wonder if Don's problem is the top of his quarters?Don here is mine original. As u can see the bottom sticks out more on mine your are recessed.
Jesse, do you have a pic of yours without the end caps on? Wonder if Don's problem is the top of his quarters?Don here is mine original. As u can see the bottom sticks out more on mine your are recessed.
Seems to me that the tail panel is to far inward. Also the center should be longer than the outside measurements. I can measure mine tomorrow from the dutchman to the tail panel molding. Are your holes in the tail panel so you can mount the molding?Ok I checked mine and I get a consistent 3 inches left, right, and in the middle
His dutchman, trunk lid and quarters line up. To me its in the tail panel. Plus his is even sides and center where the center should be longer because the trunk lid is longer in the center vs the sides.Jesse, do you have a pic of yours without the end caps on? Wonder if Don's problem is the top of his quarters?
All of the holes to mount the top molding are there except the ones on the left and right ends. they got welded overSeems to me that the tail panel is to far inward. Also the center should be longer than the outside measurements. I can measure mine tomorrow from the dutchman to the tail panel molding. Are your holes in the tail panel so you can mount the molding?
If you can put it on I will measure mine tomorrow with pictures. The molding has minor left to right adjustment but no fore ward to back adjustment. So the measurement I give you should be fairly accurate. If you look at the molding the center is v cut. That's because the tail panel should be out further at the center.All of the holes to mount the top molding are there except the ones on the left and right ends. they got welded over
Yeah, I realized that after typing. I think it is in the placement of the tailpanel as well, just hoping it's not. Don, did you happen to put the tailpanel inside of the quarter instead of on the outside like in Jesse's pics?His dutchman, trunk lid and quarters line up. To me its in the tail panel. Plus his is even sides and center where the center should be longer because the trunk lid is longer in the center vs the sides.
Sounds goodIf you can put it on I will measure mine tomorrow with pictures. The molding has minor left to right adjustment but no fore ward to back adjustment. So the measurement I give you should be fairly accurate. If you look at the molding the center is v cut. That's because the tail panel should be out further at the center.
My tailpanel is on the outside just like Jesse's picYeah, I realized that after typing. I think it is in the placement of the tailpanel as well, just hoping it's not. Don, did you happen to put the tailpanel inside of the quarter instead of on the outside like in Jesse's pics?
Hmm I didn't think about that, Ok I ordered some.One other thing is the quarter extensions will stick out a little more with those thick plastic gaskets/seals. Something to look at for total deck lid fitment.
Thanks.
If you can put it on I will measure mine tomorrow with pictures. The molding has minor left to right adjustment but no fore ward to back adjustment. So the measurement I give you should be fairly accurate. If you look at the molding the center is v cut. That's because the tail panel should be out further at the center.