1964 Plymouth Savoy Build

[Lowcar]

yep moroso and jones seem to be the same. from what i can tell the sw tachs seem to have a 5/8 connection were as the jones is 7/8 with that funky female end

 

[dmoore]

Chuck do you have a good legible photo of your distributor tag?

 

[Chuck Marshall]

Chuck do you have a good legible photo of your distributor tag?

Yes, I'll post it. It's a 2444721 dual point

 

[Chuck Marshall]

Here you go

 

[Chuck Marshall]

yep moroso and jones seem to be the same. from what i can tell the sw tachs seem to have a 5/8 connection were as the jones is 7/8 with that funky female end

Yes the SW are 5/8. The distributor end is 7/8 with a keyed cog.

 

[dmoore]

Here you go

View attachment 1238949

Thanks Chuck!

 

[Chuck Marshall]

Thanks Chuck!

Your welcome

 

[8stackhemi]

Got the reproduction Max Wedge Dual Choke Cable. Mounted it to dash and made 7/8 hole in firewall and routed to carbs.

View attachment 1228102 View attachment 1228103 View attachment 1228104 View attachment 1228105 View attachment 1228106

What a GREAT setup! Nice!

 

[Chuck Marshall]

I went to a electrical supply store (not Home Depot or Lowes lol!) and got a oil tight hole seal for a conduit box. It came with primer. I scuffed it and painted it with my left over body paint and clear. Fits nicely over the antenna hole. I also plumped the vacuum line from the engine to the push button switch and the to the opening and closing of the fresh air door on the passenger side. Works great. I’m going to run a vacuum check valve on the vacuum feed line and a small inline fuel filter to act as a vacuum reservoir so it can open or close with the engine not running. At least once or twice any way. I’ll see.

 

[Chuck Marshall]

Working on getting the front bench done. Slow progress but I don’t want mistakes. Getting it to match the rear seat.

 

[Chuck Marshall]

Got a lot of stuff done today on the Savoy. Getting it ready to take to MATS this month. Got the lower cover for the transmission bell housing.

 

[Chuck Marshall]

The front bench is finished, I’m very happy with it.

 

[Chuck Marshall]

Added the rails and mounting brackets with the springs and the adjuster wire from left to right.

 

[Chuck Marshall]

Installed the bench and tightened it to the floor.

 

[Chuck Marshall]

The rails have 3 positions to adjust the seat for I guess people of different heights. It was the best with the front of the rail in the middle position and the back in the lower position.

 

[Chuck Marshall]

Installed the other door sill moldings too.

 

[ct71rr]

Your bench came out really nice! I really like the look of the interior.

 

[Chuck Marshall]

Your bench came out really nice! I really like the look of the interior.

Thanks! Me too. I love red interior

 

[Lowcar]

a white car with red interior or a red car with white interior both look like they belong together

 

[Nxcoupe]

I went to look at a guy's cuda back in the day, and turned out it was a black 6pack car with red interior. Just an absolutely beautiful car. Wish I'd have bought it and held on to it.